![]() ![]() As such, in the "Transfer Complete" state the application would collect the available data, transmit it, and then return to idle.Īn alternative approach would have been to skip the timer interrupt kicking off the ADC conversion altogether and instead have the DMA interrupt collect data directly when it becomes available by the ADC. The DMA event signals that the ADC data is available in memory to read. The application would then return to the idle state again and wait until a DMA event happens. In the timer interrupt task, we will kick off an ADC sequence conversion that will go and collect ADC samples from all microphone channels. The application will be sitting idle until a timer interrupt event happens at a rate of our choice (for example every one second). The state machine below expresses how the application works. In software, however, we will mainly be configuring the DMA and collecting and processing microphone samples once they become available. There isn't much of an algorithm design for this application as most of the work is going to be handled by hardware through interrupts. Unless you are using a different board other than the Nucleo-F401RE, you have to check the relevant documentation (reference manual or datasheet) to determine the number of the pin. ![]() This is a hardwired pin, meaning you cannot use any other for this setup. The UART Tx line that connects to the PC through the onboard USB bridge is via pin PA2 on the microcontroller.The second Microphone signal pin is connected to pin PA4 (Grove Connector A2).The first Microphone signal pin is connected to pin PA0 (Grove Connector A0).1 x Seeed Studio Grove Base Shield V2.0. ![]() Note that if the code on the git repo is slightly different then it means that it was modified to enhance the code quality or accommodate any HAL/Rust updates.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |